汽轮机联锁保护在 DCS上的实现

阐述了汽轮机联锁保护的具体内容，并在此基础上根据需要给出了该联锁系统在DCS上的实现方法。     

苦咸水淡化处理方法探讨

针对苦成水的淡化水处理方法，分别介绍了不同方法的原理、试用性和优缺点。通过对各种方法的对比，采用反渗透膜法对不同古盐量的苦成水进行脱盐淡化处理，具有较强的适应性。膜分离技术中的反渗透法是较其他方法更为合理、有效的苦咸水淡化技术。     

尿氚的分析测量和氚人体半排期的实验研究

用液体闪烁计数法测定了本所老点核退役过程中直接和间接接触氚工作人员的尿样几十个 ,氚浓度在 1 0 2 ～ 1 0 5 Bq/L ,最大氚浓度为 2 7× 1 0 5 Bq/L ,折合剂量当量约为 0 1 9mSv。短期观测 2 3名人体氚半排期 ,其范围为 5 5～ 1 4 8d ,中期观测 5名人体氚半排期 ,其范围为 7 6～ 9 4d。 2 8名人员半排期不仅与理论值 1 0d接近 ,而且与国内外的观测值十分符合。     

还原蒸馏法分析硝基苯类化合物的探讨

由于还原偶氮比色法中锌渣、滤纸吸附对分析硝基苯类化合物有较大影响,文章采用还原后蒸馏的方法分析硝基苯类化合物,该法比滤纸过滤分析结果准确,精密性好,操作简单.     

Co-injection of air and steam for the prevention of the downward migration of DNAPLs during steam enhanced extraction: an experimental evaluation of optimum injection ratio predictions

When steam is injected into soil containing a dense volatile non-aqueous phase liquid contaminant, the DNAPL vaporized within the heated soil region condenses and accumulates ahead of the steam condensation front. If enough DNAPL accumulates, gravitational forces can overcome trapping forces allowing the liquid contaminant to flow downward. By injecting air with steam, a portion of the DNAPL vapor remains suspended in equilibrium with the air, decreasing liquid contaminant accumulation ahead of the steam condensation front, and thus reducing the possibility of downward migration. In a previous work, a theoretical model was developed to predict the optimum injection ratio of air to steam that would eliminate accumulation of DNAPL ahead of the temperature front and thus minimize the potential for downward migration. In this work, the theoretical model is summarized, and an experiment is presented in order to evaluate the optimum injection ratio prediction. In the experiment, a two-dimensional water saturated sand pack is contaminated with a known mass of TCE (DNAPL). The system is then remediated by co-injecting air and steam at the predicted optimum injection ratio, calculated based on the average contaminant soil concentration in the sand pack. Results for the co-injection of air and steam are compared to results for the injection of pure steam or pure air. Injection at the predicted optimum injection ratio for a volumetric average NAPL saturation, reduced accumulation of the contaminant ahead of the condensation front by over 90%, as compared to steam injection alone. This indicates that the optimum injection ratio prediction is a valuable tool for limiting the spreading of DNAPL during steam-enhanced extraction. Injection at the optimum injection ratio resulted in earlier recovery of contaminant than for steam injection alone. Co-injection of steam and air is also shown to result in much higher recovery rates than air injection alone.     

A theoretical model of air and steam co-injection to prevent the downward migration of DNAPLs during steam-enhanced extraction

When steam is injected into soil containing a dense volatile non-aqueous phase liquid contaminant the DNAPL vaporized within the heated soil region condenses and accumulates ahead of the steam condensation front. If enough DNAPL accumulates, gravitational forces can overcome trapping forces allowing the liquid contaminant to flow downward. By injecting air with steam, a portion of the DNAPL vapor remains suspended in equilibrium with the air, decreasing liquid contaminant accumulation ahead of the steam condensation front, and thus reducing the possibility of downward migration. In this work, a one-dimensional theoretical model is developed to predict the injection ratio of air to steam that will prevent the accumulation of volatile DNAPLs. The contaminated region is modeled as a one-dimensional homogeneous porous medium with an initially uniform distribution of a single component contaminant. Mass and energy balances are combined to determine the injection ratio of air to steam that eliminates accumulation of the contaminant ahead of the steam condensation front, and hence reduces the possibility of downward migration. The minimum injection ratio that eliminates accumulation is defined as the optimum injection ratio. Example calculations are presented for three DNAPLs, carbon tetrachloride (CCl4), trichloroethylene (TCE), and perchloroethylene (PCE). The optimum injection ratio of air to steam is shown to depend on the initial saturation and the volatility of the liquid contaminant. Numerical simulation results are presented to validate the model, and to illustrate downward migration for ratios less than optimum. Optimum injection ratios determined from numerical simulations are shown to be in good agreement with the theoretical model.     

DESIGN OF DESALTING PLANTS FOR CONJUNCTIVE OPERATION1

ABSTRACT The selection of an evaporator design must reflect the balancing of captial cost (primarily in heat exchanger surface and vessels) against operating cost (primarily steam cost) to achieve minimum cost. In a conjunctive plant the tendency is to select a low-capital cost, high-operating cost plant. In addition, it is advantageous to use a high-capacity plant which needs to be operated much less of the time than a plant which is sized just at the needed rate. For example, in the study of a possible system to satisfy a future increase of 450 MGD in water supply to New York Qty, a plant of 750 MGD capacity was selected as optimum. This plant, of the advanced VTE-MSF process type, would have a performance ratio of 9 lb product/1000 Btu as compared to 10-13 normally used for base-loaded plants. Steam would be supplied by a multi-unit dual-purpose nuclear power plant. The most economical type of energy supply would be “interruptible”; the steam would be used by a low pressure turbine to generate electricity during periods of peak electrical demand but would be available to the desalting plant at other times. The low pressure turbine would be available as spinning reserve during desalting plant operation. It is estimated that the desalting plant would have a load factor of 27 per cent over its life.     

尿中氚水和总氚的对比分析测定研究

用蒸馏液闪法测量尿中氚水浓度 ,用氧化蒸馏液闪法测量尿中总氚 (氚水和有机氚 )浓度。同时测量了 1999年核设施退役时接触氚人员的高于本底水平的尿中氚水和总氚浓度 72个样品。比较氚水和有机氚浓度 ,得到有机氚浓度占氚水浓度的平均值为 (5 4± 3 7) % ,其值与理论值和动物实验值基本相符     

分馏塔腐蚀原因分析及预防措施

针对目前炼厂原油性质越来越差,同时装置的生产周期越来越长的状况,结合生产实际对分馏塔顶部腐蚀漏液现象及原因进行了详细对比分析。提出选用合适的耐腐蚀材料、注缓蚀剂等措施,提高了设备的抗腐蚀能力,缓解了分馏塔顶部的腐蚀现象。     

轧钢污泥综合利用的技术研究

阐述了一种轧钢污泥的回收处理技术,该技术可把轧钢污泥有效地分离成氧化铁粉和混合油,实现综合利用,减少铁素资源浪费,有良好的经济效益和环境效益.